

So instead of just turning it right side up, you actually put the plug on the other side of the cable, keeping the colorsed wires in the same pin location. "It's important to note which cable is on the notched side of the connector, and to keep that wires (color) at that connector.

The M.2 SATA bus is shared with SATA Port 1, therefore if you install an M.2 SATA SSD card, SATA Port 1 (J3) will. SATA Controller Diagram¶ The above diagram shows the 2:1 MUX between SATA Port 1 and the M.2 connector. However, now that I've got a new case with a bottom mounted PSU, the SATA power cable is daisy chaining all of the HDDs upside down, hence why I've flipped them so they're the right way up. SATA plug-in detection capable, Drive power control and staggered spin-up, SATA Partial / Slumber power management state. My PSU worked perfectly in top mounted cases and you could easily daisy chain one HDD to the next. I simply flipped the connector horizontally making the connectors along the daisy chain SATA power cable upside down. Don't you think that buying a new PSU that met the requirements would have been easier?Īfter flipping them around, you still have connections that match If you have to unplug everything, be sure to follow Step 2 closely. Turn off the power switch on the back of the power supply, but leave the cable plugged in if possible. How did you flip the connectors while keeping the same wire on the same pin? If the wires are switched, then the drives either won't work or they'll be damaged. Installing a Desktop SATA Optical Drive Download Article 1 Power down your computer. You wrote "The problem is that I've had the flip all of the SATA connectors around and they weren't easy to put back on the cable." and I sure hope that I understand what you did.
